On the car 1990-1997 Honda Accord Hub/Rotor Remover
GDT5 Instuctions

1. REMOVE THE CALIPER AND BRACKET.

2. REMOVE THE 36MM AXLE NUT.

3. REMOVE 4 ROTOR BOLTS.

4. TURN ROTOR TO COVER 
THE 4 THREADED BOLTS
MAKE CERTAIN THAT THE BOTTOM OF THE REMOVER LEGS ARE ON THE FLAT SURFACE OF THE ROTOR BEFORE ROTATING THE LIFT BOLT.
SEE FIGURE 1

LUBE LIFT BOLT TREADS BEFORE EACH USE.
SEE FIGURE 2

5. THEN SLIDE THE AXLE BACK AND MOUNT THE TOOL BY INSTALLING THE LUG NUTS ON THE BOTTOM PLATE OF THE PULLER, AND TIGHTEN SECURELY.

6. USE A HAND WRENCH OR SOCKET TO ROTATE THE BOLT CLOCKWISE, UNTILL
THE HUB IS RELEASED.
(NEVER USE IMPACT WRENCH)

7. ONCE THE HUB IS REMOVED, REMOVE THE TOOL, AND THE OLD ROTOR.

8. REPLACE ROTOR, LUBRICATE
BEARING AND REINSTALL THE HUB.

9. REINSTALL THE 4 ROTOR BOLTS AND TORQUE TO SPECIFICATIONS.

10. REINSTALL 36MM AXLE NUT AND TORQUE TO SPECIFICATIONS.

View the Instructional Video



CAUTION: DO NOT CONTINUE TO ROTATE THE LIFT BOLT IF THE LEGS ARE NOT TIGHT AGAINST THE FLAT SURFACE OF THE ROTOR FLANGE. DOING SO WILL ALLOW THE REMOVER LEGS TO ENTER INTO THE THREADED HOLES OF THE ROTOR FLANGE, CAUSING DAMAGE TO THE REMOVER LEGS OR TOOL ASSEMBLY.





Photography and Website design by Watersign.com